Skip to main content

TLT2H

Status: Works today.

KindVersionPublisherLicence
Device codec1.0.0ZAITRACKApache-2.0

What it does​

TLT2H report decoder with strict checksum, batch and identity validation. Commands are unavailable: the reviewed GPRS sources establish no encoder or command acknowledgement. Extended Mictrack-format telemetry is source-tested; hardware acceptance remains open.

  • Devices: vehicle_tracker
  • Transport: tcp, udp
  • Models: TLT-2F, V520, Mictrack TLT-2H, TLT-1C, V690, VSUN3338, TLT-3A, V580, TLT-1B, TLT-2K, TLT-2N, TLT-1F, TLT-8A, TLT-8B, TLT-1D, TLT-6C, TLT-7B, AT-12A, MP10, MP80, Mictrack MP90, Mictrack MC300, Mictrack MT510, Mictrack MT500, MT510-G, Mictrack MT530, MT510G, Mictrack MT600, Mictrack MT700, MiniFinder Xtreme, Mictrack MT710, Mictrack MT600-NB
  • Commands: None.
  • Capabilities: telemetry.position

How to use it​

In Adapter Studio, an organisation's owner or admin opens Installations → Install an adapter and gives tlt2h and its settings. It runs once installed.

Configuration​

None: it needs no settings.

Credentials​

None.

Limits​

It runs in codec-runtime's WASM sandbox, within these limits (the platform's own ceilings bound them too):

  • Memory: 32 MB
  • Time per call: 50 ms
  • Instructions per call (fuel): 50,000,000
  • Largest message: 65,536 bytes
  • Calls per second: 2,000
  • Network: no network access

Troubleshooting​

  • The device does not connect. Check the host and port its Connect page gives for your region, that the SIM has data and the APN is set, and that the device sends to that host (some send to the last server they were given).
  • It connects but no position arrives. The device must be registered with this protocol and the IMEI or serial it reports: a device the platform does not know, or a retired one, is refused when it connects. Trackers shows it as Check (never reported) until its first position.
  • Positions arrive with the wrong time. The protocol's timestamps are UTC; a device set to local time reports hours off. Set it to UTC.
  • A command does not reach the device. Only the commands listed under Commands are sent; the device must be online, and some models need the command enabled in their own configuration.

Source​

adapters/codecs/tlt2h