Skip to main content

T55 / NMEA

Status: Works today.

KindVersionPublisherLicence
Device codec1.0.0ZAITRACKApache-2.0

What it does​

T55/NMEA telemetry with explicit device identity, bounded parsing, checksum verification and canonical telemetry projection. Identity must precede addressless reports. No remote commands or source-IP identity fallback.

  • Devices: vehicle_tracker
  • Transport: tcp, udp
  • Models: Gelix, Gelix-2, GoPass GPS-911(M), GoPass AVL-900, GoPass AVL-900(R), GoPass AVL-900(M), GoPass AVL-901(B), GoPass AVL-901(C), GoPass AVL-901(D), GoPass AVL-921, CradlePoint IBR600, CradlePoint IBR1100, Aspicore, Tracker for Traccar, Multi-Tech MultiConnect rCell, Four-Faith M2M IP Modem F7114
  • Commands: None.
  • Capabilities: telemetry.position

How to use it​

In Adapter Studio, an organisation's owner or admin opens Installations → Install an adapter and gives t55 and its settings. It runs once installed.

Configuration​

SettingTypeRequiredAllowed values and default
rmc_ackbooleannodefault false; Send OK1 CRLF after persisted valid TCP RMC reports. Enable only for a device profile that requires this acknowledgement.

Credentials​

None.

Limits​

It runs in codec-runtime's WASM sandbox, within these limits (the platform's own ceilings bound them too):

  • Memory: 32 MB
  • Time per call: 50 ms
  • Instructions per call (fuel): 50,000,000
  • Largest message: 4,096 bytes
  • Calls per second: 2,000
  • Network: no network access

Troubleshooting​

  • The device does not connect. Check the host and port its Connect page gives for your region, that the SIM has data and the APN is set, and that the device sends to that host (some send to the last server they were given).
  • It connects but no position arrives. The device must be registered with this protocol and the IMEI or serial it reports: a device the platform does not know, or a retired one, is refused when it connects. Trackers shows it as Check (never reported) until its first position.
  • Positions arrive with the wrong time. The protocol's timestamps are UTC; a device set to local time reports hours off. Set it to UTC.
  • A command does not reach the device. Only the commands listed under Commands are sent; the device must be online, and some models need the command enabled in their own configuration.

Source​

adapters/codecs/t55