Envotech RadioSecure e-seals (SLM, SLM-m)
Status: Works today.
| Kind | Version | Publisher | Licence |
|---|---|---|---|
| Device codec | 1.0.0 | ZAITRACK | Apache-2.0 |
What it does
Envotech RadioSecure SLM electronic seals on their ASCII GPRS records ($80SLM ... *HHHH#, ENRS72 v1.13), as ROAM ran them at Dubai Airports. Position (only a fresh fix becomes the position), GSM network, supply and battery voltage, the security switch, tamper history, the confirmed opening alarm, the SLM-m motor lock and its failures, low voltage, slave seals and sensors (temperature, humidity, fuel voltage) as children, RF infrastructure presence. Every record is answered $PA. Commands: seal-disarm and seal-arm, the motor lock of the SLM-m (930,1 / 930,0 with the unit's command password, 000000 when none is set); the unit's motor event is the answer. The record trailer is not verified: its algorithm is not documented. The SLM-i Iridium profile ($90) is not decoded. The same record arriving by SMS decodes the same way once its STX is restored to '$'.
- Devices:
e_seal - Transport:
tcp - Commands:
seal-disarm,seal-arm - Capabilities:
telemetry.position,telemetry.seal,command.seal
How to use it
In Adapter Studio, an organisation's owner or admin opens Installations → Install an adapter and gives envotech-radiosecure and its settings. It runs once installed.
Configuration
| Setting | Type | Required | Allowed values and default |
|---|---|---|---|
password | string | no | default "000000"; The six-digit password the seal checks on every command. A device's own setting in the device registry wins. |
Credentials
None.
Limits
It runs in codec-runtime's WASM sandbox, within these limits (the platform's own ceilings bound them too):
- Memory: 32 MB
- Time per call: 100 ms
- Instructions per call (fuel): 2,000,000,000
- Largest message: 65,536 bytes
- Calls per second: 8,000
- Network: no network access
Troubleshooting
- The device does not connect. Check the host and port its Connect page gives for your region, that the SIM has data and the APN is set, and that the device sends to that host (some send to the last server they were given).
- It connects but no position arrives. The device must be registered with this protocol and the IMEI or serial it reports: a device the platform does not know, or a retired one, is refused when it connects. Trackers shows it as Check (never reported) until its first position.
- Positions arrive with the wrong time. The protocol's timestamps are UTC; a device set to local time reports hours off. Set it to UTC.
- A command does not reach the device. Only the commands listed under Commands are sent; the device must be online, and some models need the command enabled in their own configuration.
Source
adapters/codecs/envotech-radiosecure