CalAmp LMU GPS Tracker
Status: In development: its code is written and tested on its own, but it does not work end to end on the platform yet. It cannot be installed.
| Kind | Version | Publisher | Licence |
|---|---|---|---|
| Device codec | 1.0.1 | ZAITRACK | Apache-2.0 |
What it does
CalAmp LM Direct, the UDP protocol of the LMU series: the options header names the unit (its mobile id), event reports (2), locate reports (8) and mini event reports (10) become positions with the PEG event code, inputs, RSSI and accumulators; acknowledged requests are answered with an ACK. No commands are sent (unit requests depend on the unit's PEG script). In development: bounded synthetic direct-UDP reports and ACKs are checked against the CalAmp-attributed PULS guide export printed 2013-12-13. Standard and Enhanced32 accumulator formats are supported. Routed replies, device/firmware and lifecycle acceptance remain open; it is published for review only, never approved.
- Devices:
vehicle_tracker - Transport:
udp - Commands: None.
- Capabilities:
telemetry.position,telemetry.io
How to use it
Not yet: see its status above.
Configuration
None: it needs no settings.
Credentials
None.
Limits
It runs in codec-runtime's WASM sandbox, within these limits (the platform's own ceilings bound them too):
- Memory: 32 MB
- Time per call: 100 ms
- Instructions per call (fuel): 2,000,000,000
- Largest message: 65,536 bytes
- Calls per second: 8,000
- Network: no network access
- Its own key-value store: up to 1,024 keys of 4,096 bytes
Troubleshooting
- The device does not connect. Check the host and port its Connect page gives for your region, that the SIM has data and the APN is set, and that the device sends to that host (some send to the last server they were given).
- It connects but no position arrives. The device must be registered with this protocol and the IMEI or serial it reports: a device the platform does not know, or a retired one, is refused when it connects. Trackers shows it as Check (never reported) until its first position.
- Positions arrive with the wrong time. The protocol's timestamps are UTC; a device set to local time reports hours off. Set it to UTC.
- A command does not reach the device. Only the commands listed under Commands are sent; the device must be online, and some models need the command enabled in their own configuration.
Source
adapters/codecs/calamp-lmu